How to link?
Situation: 2 MS WINXP PC
           1 Wireless 3COM Router
           1 Wireless USB Adapter
           1 Ethernet Broadband Modem

Problem: I can't see each other in the My Network Places.
         Both are using same workgroup, but can't see each
         other. Worse still, one of the pc can't see itself
         in its own network place? I try to link by using  
         the setup up home networking. But failed.
         Previously, win98 can link with the XP, but now
         after upgrade win98 to XP, problems start to surface

Any solutions?

Sorry, I forget to mention that I did a clean install of WIN XP PRO instead of upgrade

Hi Jamez

Just looking at your spec list, you only mention 1 USB Wireless adapter. Is that a typo? Or is the router connected to a pc via a Cat5 cable?

I would first of all get the router set up.  The DHCP server part is especially important as this will assign the IP addresses to each computer.

You shouldn't really need to resort to the Network Setup Wizard, the DHCP will assign the correct settings for you.

Post back and let me know if I've missed the point completely

You said one PC cannot see itself. I would say that this one is more likely to be the one with the problem. Is it the wireless PC or the one connected to the router?

If it is the wireless one, have you checked that the wireless card is recieving a signal and that it is actually connecting to the router? Usually this is part of the network properties for the card, which you can get from Network Connections.

Another thing to check, while you are there, is that the IP addresses assigned to the network card and wireless card are compatible. Usually the router is assigned 192.168.1.1 and the cards 192.168.1.x where x is unique for each card. All devices usually have a subnet mask of 255.255.255.0.

Hope this helps

And the router has assigned 192.168.1.2 and 192.168.1.3 for PC1 and PC2 respectively.

I think that may be your problem jamez. PC1 and PC2 need to be on different IP addresses, say 192.168.1.3 and 192.168.1.4

:damn: That's what reading postings quickly in work, between jobs does for you.

I read it as the router was assigned 192.168.1.2 and the other PCs were both on 192.168.1.3. Ho hum... back to the drawing board.

If PC2 is seeing the Internet, but not the network, the wireless card must be working. Can you ping the router (192.68.1.1 ??) or PC1 (192.168.1.2) from PC2 and vice versa Jamez?

It might also be an idea to check that the Client for Microsoft Networks is loaded in the Local Area Connection properties.

I think at this point Jamez, I'd be inclined to delete the Local Area Connection connectiod (good word that innit? ) and run the Network Setup Wizard again.

I'm running out of ideas now  

Could it be a hardware fault with the wireless bits,either the router or the usb parts? Rather than the actual software bit.
Is it one of the routers that can be wired as well to elimate a RF problem?